← Spannero Workshop

Engineering & Maintenance

Why Do Pneumatic Cylinders Sometimes Move Slowly in One Direction?

Double-acting pneumatic cylinder showing extension, retraction and airflow speed control

🔧 **WHY DOES A PNEUMATIC CYLINDER MOVE SLOWLY IN ONE DIRECTION?**

The cylinder extends perfectly, but takes forever to retract. Sound familiar?

Before blaming the cylinder itself, think about the airflow.

On many double-acting pneumatic systems, speed is controlled by restricting the air **leaving** the cylinder, not the air entering it. This is called *meter-out control*.

If the exhaust air cannot escape freely enough, movement slows down.

Common suspects include:

🔸 Incorrectly adjusted or blocked flow controls

🔸 Restricted exhaust ports or clogged silencers

🔸 Kinked or damaged air tubing

🔸 A sticking directional control valve

🔸 Increased mechanical friction or load

🔸 Insufficient pressure or airflow under operating conditions

**Workshop tip:** Identify which direction is affected, then trace the air supply and exhaust paths for that movement.

Don't just turn up the regulator and hope for the best!

💬 What's the strangest cause you've found for a slow-moving cylinder?

**spannero | For people who like to know how things work.**

More on this

### Understanding meter-out speed control

A double-acting pneumatic cylinder has two working chambers. When compressed air enters one chamber, air must leave the opposite chamber to allow the piston to move.

With meter-out speed control, a one-way flow control restricts the exhaust air to regulate the cylinder's speed.

During extension, air normally exhausts from the rod-end chamber. During retraction, air normally exhausts from the cap-end chamber.

This means a cylinder that moves normally in one direction but slowly in the other may have a restriction affecting only that particular airflow path.

### Where to investigate

Start by establishing whether the cylinder has always moved at this speed or whether its behaviour has changed.

Check the relevant flow controls, pipework, directional valve and exhaust silencers. Also consider whether the mechanical load is greater in one direction.

A pressure gauge may show normal pressure when the equipment is stationary, even though pressure falls during operation.

**Safety:** Follow your site's isolation procedures before working on pneumatic components. Depressurise stored energy and secure any load that could move unexpectedly. Only make adjustments or conduct operational tests under the appropriate safe working procedure.

Keep exploring the workshop

Practical references and original designs for people who like to know how things work.

The Field Reference More workshop posts